Aiphone IXW-MA - Network Settings

8 | IXG Commercial Quick Start Programming Guide
Navigate to Network Settings, NTP. It is recommended to enable and congure NTP settings for each station
when possible. For systems with the IXGW-GW gateway adaptor, it will have NTP enabled and an Aiphone
NTP server address set by default. Adjusting this default server address is possible, and recommended for sites
with their own server. Click
Save
.
NTP
Network Settings
From the side menu, navigate to Network Settings, IP Address. Each station can be manually assigned an IP
address, or click near the top of the screen to enter an IP address range to automatically assign all stations.
IP Address
Typically, stations deployed across a
managed network cannot be found
by Support Tool unless the network
is congured to allow this broadcast
search. In this case, it may be easier
to move the stations to a switch
local to the programming PC than it
would be to congure the network
to allow a network-wide broadcast.
More network settings can be seen by scrolling right. For systems with the IXGW-(T)GW gateway adaptor,
a default gateway and a primary DNS server must be added for the adaptor, and optionally for all other
stations. A secondary DNS server can also be optionally added. Consult the network administrator for more
information if needed. Once everything is congured, click
Save
.