What to do if the Aircare HORIZON shows 'F' before it's empty?
If the refill display shows “F” before the reservoir is empty in your Aircare Humidifier, make sure the unit is set up on a level surface, both side to side and front to back. This ensures the float can properly sense the water level.
What does it mean when Aircare Humidifier displays alternating 'CF'?
If your Aircare Humidifier displays alternating “CF” and room humidity, the wick may be dirty. Replace the wick if needed. You can also unplug the unit for 30 seconds and plug it back in to clear the display.
What does it mean when my Aircare Humidifier display flashes “20”?
If your Aircare Humidifier display flashes “20”, it indicates that the room humidity is lower than 20%. The display will read the actual humidity when the level comes up to 25%.
What does it mean when Aircare HORIZON Humidifier alternates 'F' and humidity?
If your Aircare Humidifier displays alternating “F” and room humidity, it means the reservoir is empty. Fill the humidifier with water.
How to fix a digital display not illuminated on Aircare HORIZON Humidifier?
If the digital display of your Aircare Humidifier isn't illuminated, check that it's connected to a working 120-volt power source. Also, ensure you've pressed the power button once to turn the unit on.
Why is the Aircare HORIZON fan running continuously?
If the fan in your Aircare Humidifier is running continuously, it might be due to several reasons. First, check if the float retainer is in the “Manual Dryout” position; if so, reposition it to the bottom slot for normal operation. Ensure nothing is obstructing the float. Also, if the set humidity level is at 65%, the fan will run continuously; adjust it to between 25% and 60%. Finally, the fan will run until the desired humidity level is reached, which may initially take up to 48 hours.
What to do if Aircare HORIZON fan is not operating?
If the fan on your Aircare Humidifier isn't operating but the digital display is lit, it could be because the humidity level is not 3% or more below the set humidity level. If desired, raise the set humidity level or increase the fan speed. Another reason could be that the reservoir is empty, so fill the humidifier with water.
Why is water running out of the back of my Aircare Humidifier?
If you see water running out of the back of your Aircare Humidifier, it could be due to water splashing during filling. Try deflecting the fill water off the center of the splash guard. Also, make sure you are not adding too much water; do not overfill past the “Full” label in the cabinet.
How to unlock controls on Aircare Humidifier?
If the controls on your Aircare Humidifier are unresponsive or “CL” is displayed, the CONTROL LOCK feature has likely been activated. To deactivate it, hold the power button down for 5 seconds.
Why is my Aircare HORIZON Humidifier not evaporating water well?
If your Aircare Humidifier shows poor evaporation of water, and the CHECK FILTER (CF) message is flashing, it may be due to mineral buildup on the filter (wick). Change to a fresh new wick. Note that local water varies and minerals can build up rapidly in the wick under certain conditions. You can also unplug the unit for 1-2 minutes to reset the CF function.
General| Brand | Aircare |
|---|---|
| Model | HORIZON |
| Category | Humidifier |
| Language | English |
To Next Page