EasyManuals Logo

AirLive WL-5460AP Manual

AirLive WL-5460AP
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Emergency Repair with AirLive 11g AP
Applicable Models:
WL-5460AP, WL-5450AP, WL-5470AP, WL-5470POE, WH-5420CPE
The following table shows how to judge the state of the AP by looking at its LED.
LED Status Table
Model Normal Condition Firmware Crashed Bootloader Crashed
WL-5450AP,
WLA-5460AP,
WL-5470AP,
WL-5470POE
z WLAN LED will
light up
z Status LED will be
off
Status LED stay
constantly on
Both Status and
WLAN LED are off
Firmware Crashed: You can use the Emergency upgrade procedure in this section
to restore the AP
Bootloader Crashed: You need to send the unit back to AirLive for repair.
Emergency Firmware Upgrade
The AirLive 11g Access Points features emergency firmware upgrade function that
can restore your AP from a firmware crashed. If you can’t access your AP
anymore, please first try to restore the setting to default by holding the RESET
button (in the back) for more than 5 seconds. You should be able to find the AP
at 192.168.100.252. If you can’t find it and the status LED stays RED after
power-on for 10 minutes, then please perform the emergency upgrade.
AirLive Wireless Workshop Page. 1

Other manuals for AirLive WL-5460AP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AirLive WL-5460AP and is the answer not in the manual?

AirLive WL-5460AP Specifications

General IconGeneral
Modulation16-QAM, 64-QAM, BPSK, DBPSK, DQPSK, QPSK
Channels quantity13 channels
Cabling technology10/100Base-T(X)
Ethernet LAN data rates10, 100 Mbit/s
Maximum data transfer rate54 Mbit/s
Power LEDYes
Frequency range2.412GHz - 2.472GHz MHz
Networking featuresEthernet, Fast Ethernet
Compliance industry standardsIEEE 802.3, IEEE 802.3u, IEEE 802.11b, IEEE 802.11g, IEEE 802.1x
Supported data transfer rates54, 48, 36, 24, 18, 11, 5.5, 2, 1Mbps
Antenna featuresDipole antenna
Antenna connector typeRP-SMA
Antenna gain level (max)2 dBi
InternalNo
LED indicatorsLAN, Link, Power, Status, WLAN
Ethernet LAN (RJ-45) ports2
Security algorithms128-bit WEP, 64-bit WEP, 802.1x RADIUS, EAP-TLS, TKIP, WDS, WPA, WPA2
Storage temperature (T-T)-20 - 65 °C
Operating temperature (T-T)0 - 60 °C
Storage relative humidity (H-H)0 - 95 %
Operating relative humidity (H-H)20 - 80 %
Output power description20dBm
Flash memory2 MB
Internal memory16 MB
Internal memory typeDDR
Supported network protocolsDHCP, PPTP, L2TP, PPPoE ISP
Weight and Dimensions IconWeight and Dimensions
Weight900 g
Dimensions (WxDxH)100 x 135 x 26 mm

Related product manuals