AIRMAC T20D - Maintenance Schedules; Lubricating Oil Management

Instruction Manual
Airmac Air Compressors
2019-06-07
© Glenco Air & Power Pty Ltd
33
Table 7-1
Recommended Maintenance Schedule for Oil Lubricated Compressors
Elapsed Time or Operating Hours (whichever occurs first)
Activity 1 Day 1 Week
1
Month
3 Mths
or
500 h
1 Year
or
2,000 h
2 Years
or
4,000 h
Check Oil Level
●
Inspect for Oil Leaks
●
Drain Air Tank and Filter-Regulator
●
Check or Clean Air Filter(s)
●
Test Safety Valve
●
Inspect for Air Leaks
●
Check V-Belt(s)
●
Tighten Joints and Fasteners
●
Clean Unit
●
Replace Oil
●
Replace Air Filter(s)
●
Replace Filter-Regulator
●
Replace V-Belt(s)
●
Table 7-2
Recommended Maintenance Schedule for Oil Free Compressors
Elapsed Time or Operating Hours (whichever occurs first)
Activity 1 Day 1 Week
1
Month
3 Mths
or
500 h
1 Year
or
2,000 h
4,000 h 8,000 h
Drain Air Tank
●
Check or Clean Air Filters
●
Test Safety Valve
●
Inspect for Air Leaks
●
Check V-Belts
●
Tighten Joints & Fasteners
●
Clean Unit
●
Replace Air Filters
●
Replace V-Belts
●
Replace Piston Rings and
Guides
●
Check or Replace Cylinder
Head Valves
●
Replace Compressor Pump
●
7.3 Lubricating Oil
Maintain the oil level at the top of the red circle or at the “H” mark on the oil sight glass fitted to the
compressor pump as shown in Figure 6-1.
Remove the oil fill cap to add oil only when the compressor is switched off.
Use premium quality engine oil of monograde or multigrade viscosity that is appropriate for the