© Glenco Air & Power Pty Ltd
1.0 Safety
The air compressor set should only be operated by authorised persons. All users should follow the
instructions and safety warnings as (a) described in this instruction manual, (b) shown on any decals
affixed to the unit and (c) described in the Plant Risk Assessment that’s also available from the
manufacturer.
Read and understand the separate instruction manual for the compressor’s petrol or diesel engine, if
so equipped, before operating the unit.
You must take reasonable care for the health and safety of both yourself and any others who may be
affected by your actions. You should understand and follow all of the safety rules and working
instructions described herein. You should also use your own good judgement and common sense.
All users of the compressor and any other workers likely to be in the vicinity thereof should undergo
training to achieve the requisite minimum level of operator competence before placing the unit into
service.
Do not permit anyone to operate the compressor without proper instruction.
The compressor should be installed or operated in a horizontal position on a firm, level and
stationary foundation such as a concrete floor that is strong enough to support its weight. The unit
should not impede pedestrian or vehicular traffic.
Do not locate the compressor where chemicals, dust, dirt, fibres, oil, salt, water, or flammable or
explosive liquids, gases or dusts may be present. The area should not be wet or damp. The unit
should be kept away from other heat sources.
Engines, motors and electrical equipment can cause heat, sparks or flames that may ignite a
flammable gas or vapour. Do not operate or repair the compressor in or near a flammable gas or
vapour. Do not store flammable liquids or gases in the vicinity of the compressor.
High voltage electricity can cause death or serious injury. All electrical installation, maintenance or
repair work should be performed by a licensed electrician.
Electric-powered compressors should be installed in a well-ventilated area preferably indoors. If it
has to be located outdoors, the unit should be provided with weather protection against
precipitation and direct sunlight.
Electric-powered compressors should be connected to a properly grounded electrical supply of
adequate capacity. The electricity supply circuit should comply with the AS/NZS 3000:2018 Wiring
Rules. It should include a fixed setting residual current device (RCD) with a rated operating residual
current not exceeding 30 mA.
Do not operate an electric-powered compressor in wet conditions. Store it indoors.
Petrol or diesel engine-powered compressors should only be installed or operated outdoors in a well-
ventilated area away from building doors, windows and vents.
Petrol and diesel fuels are flammable and poisonous and can cause death or serious injury. Do not
smoke or allow flames or sparks close to the engine.
To Next Page
Loading...