To Next PageTo Next Page
Need help?Do you have a question about the Airmax MaxAir 100 LV and is the answer not in the manual?
Guides the user on selecting the correct fan coil model based on heat load and outlet requirements.
Provides instructions for mounting the unit in various configurations, including pump shaft orientation.
Details installing a sediment faucet for drain/purge, isolation valves, and lead-free solder for piping.
Explains installation of accessory slab cooling coils, TX valve, and drain pan trap requirements.
Details unit installation for condensate drainage and proper clearances for service and piping.
Guides on locating the outdoor unit, maintaining clearances, and ensuring it is level and supported.
Explains the anti-ice control thermostat, TXV bulb placement, and insulation for proper operation.
Provides guidelines for installing refrigerant piping, including insulation and traps to prevent liquid migration.
Details the process of pressurizing the system, checking for leaks, and evacuating/charging with refrigerant.
Introduces the microcontroller-based electronic volume controller for fan coils.
Details the layout of the DCC7235 board and its power supply requirements.
Explains 0-10VDC command input and its representation of PWM output.
Describes discrete 24VAC inputs, their specifications, and outputs.
Details dip-switch settings for selecting discrete or variable PWM output signal levels.
Describes operation with furnaces and heat pumps for single and two-stage heating.
Provides wiring options for true 2-stage heating/cooling and timed 2-stage heating.
Instructs on purging air from the heating loop and domestic water systems before operation.
Provides solutions for pumps not running or making noise, often due to air or hard water.
Addresses insufficient heat, cold water at faucet, and heating during off-cycle issues.
General| Brand | Airmax |
|---|---|
| Model | MaxAir 100 LV |
| Category | Air Handlers |
| Language | English |
