To Next PageTo Next Page
Need help?Do you have a question about the Airmax MaxAir 70e P3 and is the answer not in the manual?
Provides guidance on determining the optimal number of diffusers for system design.
Guides the user on how to select the appropriate MaxAir™ fan coil model based on heat load.
Instructions and precautions for securely mounting the MaxAir(e)™ combo air handler.
Steps for evacuating and charging the refrigeration system, including leak detection.
Diagram and overview of the DCC7235 microcontroller-based electronic volume controller.
Specifies the 24VAC power requirements and transformer rating for the control system.
Details the different types of control system inputs, including 0-10VDC and switched 24VAC.
Configuration options for selecting blower speeds and airflow levels using DIP switches.
Configuration for single and two-stage heating operations, including heat pump and furnace modes.
Specific operating sequences for heat pump systems during heating cycles.
Step-by-step instructions for safely starting up the air handler and associated systems.
Explains how the zone controller manages thermostats, dampers, and HVAC equipment.
Details how zone panels interact with multi-stage HVAC equipment for optimal comfort.
Instructions for configuring zone panels using DIP switches for various system types.
Provides a checklist for installers to ensure proper functioning of the zoning system.
Guidance on filter installation, cleaning, and replacement to maintain system performance.
Troubleshooting steps for external pump not running or being noisy.
Troubleshooting insufficient heat, cold water at faucet, and heating during off cycle.
Step-by-step diagnostic procedures for the 2-zone panel.
Detailed troubleshooting steps for the 3-zone panel.
Schematic illustrating the wiring for the P2 unit, including zone control and accessories.
Wiring schematic for the P3 unit, detailing connections for zone control and accessories.
Specific wiring modifications required for P2 units when used with a heat pump.
Wiring modifications for P3 units to enable proper heat pump operation.
Guidelines for applying zone systems with heat pump condensing units, including wiring modifications.
Specific wiring and configuration steps for a two-zone heat pump system.
Describes the operational sequence for heat pump heating, including delays and switchover.
General| Brand | Airmax |
|---|---|
| Model | MaxAir 70e P3 |
| Category | Air Handlers |
| Language | English |
