To Next PageTo Next Page
Need help?Do you have a question about the Airmax MaxAir 70eP2 and is the answer not in the manual?
Guides on determining the quantity of diffusers needed based on heat load calculations.
Provides guidelines for optimal placement and performance of diffusers.
Offers advice on locating and designing main trunk ducts for self-balancing systems.
Guides the selection of the appropriate MaxAir™ fan coil model based on heat load.
Provides guidance on securely suspending and mounting the air handler unit.
Details the installation of ½" (12mm) sediment faucet for drain/purge valve.
Covers the installation of the accessory slab cooling coil and TX valve.
Recommends optimal placement for diffusers based on room layout and construction.
Advises on locating the fan coil unit according to designer's layout.
Recommends lining the first five feet of return air duct with acoustic insulation.
Details the installation of 2½" diameter branch ducts, including insulation and sealing.
Describes the assembly and installation of diffusers, elbows, and extensions.
Explains the process of evacuating and charging the refrigerant system.
Details critical steps for safely starting up the air handler and water heater.
Emphasizes filter installation, cleaning, and replacement for warranty.
Provides guidance for common issues like pump failure or noise.
Lists actions to verify transformer output, wiring, and thermostat settings.
Provides a step-by-step guide for troubleshooting the 2-zone panel.
Offers a step-by-step guide for troubleshooting the 3-zone panel.
General| Hertz | 60 |
|---|---|
| CFM | 2000 |
| Airflow | 2000 CFM |
| Cabinet | Galvanized Steel |
| Insulation | Foil-faced insulation |
