AirSep
®
Corporation
5-2 AS-A—AS-P Series Instruction Manual
5.2 Pre-installation Guidelines
Before you install the oxygen generator, and the oxygen receiver, if supplied, refer
to the Specifications section in the Appendix of this instruction manual to determine
the applicable floor space, feed air, and the power requirements for your particular
model.
The oxygen generator may use feed air at specifications outside
those shown in the Appendix of this instruction manual;
however, use of such feed air may require modification of the
oxygen generator at the AirSep Corporation factory to ensure
the product oxygen meets the specifications. Consult your
sales representative to determine whether your oxygen
generator requires modifications for your application.
Locate the oxygen generator in an area where the ambient air
temperature remains between 4
qC (40qF) and 40qC (104qF) to
prevent damage not covered under the AirSep Corporation
Product Warranty.
To prevent fire or electrical shock, locate the oxygen generator
away from rain or any other type of moisture.
AirSep oxygen generators are sold for indoor use only. Make
sure the area that surrounds the oxygen generator is well
ventilated, and provide sufficient space around the unit [at least
one meter (three feet)] to allow for cool air flow as well as to
allow safe operation and maintenance.
Do not disconnect protective earth:
To Next Page
Loading...
Need help?
General
