To Next PageTo Next Page
Need help?Do you have a question about the Airwell SX 12 RCC and is the answer not in the manual?
Warning regarding careful consideration of condensate evacuation points during wall mounting.
Details and components for condensate draining from the outdoor unit.
Mandatory system for preventing condensate freezing in cold outdoor conditions.
Guide for positioning and forming tubing on the wall support for correct connection.
Information about the slanted hole for rear output to prevent entry of condensates or rain.
Steps for removing the intake grid and side panels of the indoor unit SX.
Instructions for connecting and installing the condensate evacuation tube, including slope and insulation.
Detailed steps for connecting pipes, tightening valves, and performing the vacuuming process.
Table detailing R22 charge amounts to be added on-site for various models.
Table providing R22 charge adjustments based on the length of coolant connections.
Instructions for configuring the unit for heat pump or cooling-only operation via model plug changes.
Important note on the correct orientation of the model plug for electrical connections.
Procedure for resetting the remote control and setting DIP switches for various operating modes.
Disclaimer stating that electrical specifications are for guidance and require verification.
Detailed descriptions of all indicator lights and control buttons on the indoor unit.
Procedure for cleaning air filters and the unit interior, including indicator reset.
Precautions for electronic system protection, interference avoidance, and battery replacement.
Procedures for routine servicing and visual inspection of the installation.
Maintenance guidelines for outdoor coolant systems and indoor unit air filters.
Steps for disassembling the indoor unit to install the rear air distribution kit.
General