How to fix Airwell Air Conditioner units operating in the wrong mode?
If your Airwell Air Conditioner is operating in the wrong mode (e.g., cooling instead of heating), there may be an electronics or reversing valve (RV) problem. Checking the RV might resolve the issue.
What to do if my Airwell Air Conditioner compressor motor is generating noise but no suction occurs?
If the compressor motor in your Airwell Air Conditioner is noisy but there's no suction, the phase order to the compressor is likely incorrect. You should check the compressor phase order.
What to do if my Airwell Air Conditioner indoor fan does not start?
If the indoor fan of your Airwell Air Conditioner doesn't start, first ensure the unit isn't in heat mode with a coil that's not yet warm; if so, switch to cool mode. Also, check if the outdoor unit is in the opposite mode and change the operation mode accordingly. Check power supply to motor is higher than 130VAC (for triack controlled motor) or higher than 220VAC for fixed speed motors, if OK replace capacitor, if not OK replace controller.
Why is my Airwell Air Conditioner compressor stopping during operation?
The compressor in your Airwell Air Conditioner might be stopping during operation due to electronic control issues or refrigerant leakage. Checking the refrigeration system might resolve the issue.
What to do if my Airwell Air Conditioner has water leakage from the indoor unit?
If you notice water leakage from the indoor unit of your Airwell Air Conditioner, the drainage tube is likely blocked. Inspect the drainage tube and clear any blockages.
Why is my Airwell Air Conditioner not cooling or heating even though all components are operating?
If your Airwell Air Conditioner's components are running but there's no cooling or heating, it's likely due to a refrigerant leak. Checking the refrigeration system is recommended.
Why is the indoor fan of my Airwell SX 18 DCI not starting?
Key technological and system features of the multi-split inverter.
Detailed specifications for the TRIO-72 DCI outdoor unit.
Detailed specifications for the QUATTRO-80 DCI outdoor unit.
Specifications for various indoor unit models.
Defines operational temperature and voltage limits for the system.
Physical dimensions of FLO 9/12 DCI indoor units.
Physical dimensions of TRIO-72 and QUATTRO-80 DCI outdoor units.
Performance data for Trio-72 DCI outdoor unit combinations.
Performance data for Quattro-80 DCI outdoor unit combinations.
Performance data for FLO 9 DCI indoor unit.
Correction factor based on refrigerant tubing length.
Correction factors applicable to different unit models.
Pressure curves for the TRIO-72 DCI model.
Pressure curves for the QUATTRO-80 DCI model.
Example calculation for pressure values.
Electrical specifications for Trio-72 and Quattro-80 DCI units.
Wiring diagram for the outdoor units.
Refrigerant system diagram for TRIO-72 and QUATTRO-80 DCI.
Glossary of terms used in the control system.
General overview of the control system architecture.
Rules for system operation and initialization procedures.
Control logic and settings for indoor units.
System operational modes and their controls.
Management of compressor speed based on operating conditions.
Control logic for Electronic Expansion Valves.
System protection mechanisms and levels.
Mode for technicians to test system functionality.
Description of the user interface and navigation menus.
Common system failures and their recommended corrective actions.
Error codes and diagnostic information for system issues.
Steps to check and verify key system components.
Important safety precautions and advisories.
Exploded view of the Trio-72 DCI outdoor unit.
Spare parts list for the Trio-72 DCI outdoor unit.
Exploded view of the Quattro-80 DCI outdoor unit.
Spare parts list for the Quattro-80 DCI outdoor unit.
Reference to the installation and operation manual.
To Next Page
General
