ENGLISH 15
Tape player
The player does not move when you press an
operation button.
• Close the cassette compartment securely.
The w REC does not function.
• Make sure the cassette tab for the side is not broken
(see page 13).
The player does not erase completely.
• Clean the erasing head (see page 13).
• Replace all the batteries with new ones if they are
weak.
• The source which was recorded on TYPE II (high
position) or TYPE IV (metal) tape by this unit is being
played. Record on TYPE I (normal) tape and play.
The player does not record.
• Make sure the tape is inserted properly.
• Make sure the cassette tab for the side is not broken
(see page 13).
The audio is weak/The audio quality is poor.
• Clean the heads, pinch roller and capstan.
• Demagnetize the heads using a demagnetizer.
The sound is distorted.
• TYPE II (high position) or TYPE IV (metal) tape is
being used. Use TYPE I (normal) tape only.
Remote control
The remote does not function.
• Replace all the batteries in the remote with new ones
if they are weak.
• Make sure that you are pointing the remote at the
player.
• Remove any objects that block the remote signal to
the player.
• Make sure the player is not exposed to intense light,
such as direct sunlight or fluorescent lamp.
• Move closer to the player when using the remote.
If you still have problems after trying the above
Try to reset the player.
1 Turn off the player.
2 Turn the power back on while holding down both
E and REPEAT/MODE.
If the player cannot be reset in the way above,
disconnect the AC power cord and remove all the
batteries. Leave the player for a while and turn the
power back on.
If the problem persists, please consult your nearest
Aiwa dealer.
To Next Page
Loading...
Need help?
General
