AJAX DoorProtect User Manual

Connecting a Third-Party Wired Detector
A wired detector with the NC contact type can be connected to DoorProtect
using the outside-mounted terminal clamp.
We recommend to install a wired detector at a distance not exceeding 1 meter —
increasing the wire length will increase the risk of its damage and reduce the
quality of communication between the detectors.
To lead out the wire from the detector body, break out the plug:
1. outside the premises (outdoors);
2. nearby any metal objects or mirrors causing attenuation or interference of
the signal;
3. inside any premises with the temperature and humidity beyond the
permissible limits;
4. closer than 1 m to the hub.

AJAX DoorProtect Specifications

General

Battery life	Up to 7 years
Tamper alarm	Yes
Operating humidity	Up to 75%
Protection Class	IP50
Type	Wireless
Detection distance	1 cm
Communication range	Up to 1, 200 m in an open space
Battery type	CR123A battery
Operating temperature range	-10°C to +40°C
Dimensions	20 x 90 mm
Radio frequency	868.0 - 868.6 MHz
Compatibility	Hub