DoorProtect consists of two parts: the detector with a sealed contact reed relay,
and the constant magnet. Attach the detector to the door frame, while the
magnet can be attached to the moving wing or sliding part of the door. If the
sealed contact reed relay is within the coverage area of the magnetic eld, it
closes the circuit, which means that the detector is closed. The opening of the
door pushes out the magnet from the sealed contact reed relay and opening the
circuit. In such a way, the detector recognizes the opening.
Attach the magnet to the RIGHT of the detector.
A small magnet works at a distance of 1 cm, and the big one — up to 2 cm.
After actuation, DoorProtect immediately transmits the alarm signal to the hub,
activating the sirens and notifying the user and security company.
Pairing the Detector
Before starting pairing:
Only users with administrator rights can add the device to the hub.
How to pair the detector with the hub:
1. Following the hub instruction recommendations, install the on your
smartphone. Create an account, add the hub to the app, and create at least
one room.
Ajax app
2. Switch on the hub and check the internet connection (via Ethernet cable
and/or GSM network).
3. Make sure that the hub is disarmed and does not update by checking its
status in the app.
To Next Page
Loading...
Need help?
General
