AJAX FireProtect 2 User Manual

If temperature threshold exceeded
When this option is enabled, the
connected to the system are activated when the
detector detects a temperature threshold
exceeding.
If rapid temperature rise detected
When this option is enabled, the
connected to the system are activated when the
detector detects a rapid temperature rise.
If smoke detected
When this option is enabled, the
connected to the system are activated when the
detector detects smoke.
Jeweller Signal Strength Test
Switches the detector to the Jeweller signal
strength testing mode. The test helps determine
the optimal place for installing FireProtect 2.
The test shows the signal strength between the
detector and the hub or radio signal range
extender via the Jeweller wireless data transfer
protocol.
The recommended value is two or three bars.
Smoke Sensor Self-test
Runs a detector self-test.
User Guide
Opens FireProtect 2 User Manual in the Ajax
app.
Permanent Deactivation Allows to deactivate the device without
removing it from the system. Three options are
available:
Ajax sirens
Ajax sirens
Ajax sirens
Learn more
Learn more
No — the device operates in normal mode.
Lid only — detector’s tamper triggering
notications are disabled.
Entirely — the detector does not execute
system commands, does not participate in
automation scenarios, and does not send
notications of alarms, malfunctions, and
other events to the CMS and system users.
In this case, the detector will continue to

AJAX FireProtect 2 Specifications

General

Brand	AJAX
Model	FireProtect 2
Category	Security System
Language	English