If the detector is torn off from the surface or removed from the attachment
panel, you will receive the notification.
Do not install the detector:
1. outside the premises (outdoors)
2. in the direction of the window, when the detector lens is exposed to direct
sunlight)
3. opposite any object with the rapidly changing temperature (e.g., electrical
and gas heaters opposite any moving objects with a temperature close to
that of the human body (oscillating curtains above the radiator)
4. at any places with fast air circulation (air fans, open windows or doors)
nearby any metal objects or mirrors causing attenuation and screening of
the signal
5. within any premises with the temperature and humidity beyond the range of
permissible limits
6. Closer than 1 m from the hub.
Detector Maintenance
Check the operational capability of the Ajax Motion Protect detector on a
regular basis.
Clean the detector body from dust, spider webs and other contaminants as
they appear. Use soft dry napkin suitable for equipment maintenance.
Do not use any substances containing alcohol, acetone, gasoline and other
active solvents for cleaning the detector. Wipe the lens very carefully and
gently – any scratches on the plastic may cause reduction of the detector
sensitivity.
The pre-installed battery ensures up to 5 years of autonomous operation
(with the inquiry frequency by the hub of 3 minutes). If the detector battery
is discharged, the security system will send respective notices and the LED
will smoothly lights up and goes out, if the detector detects any motion or if
the tamper is actuated.
To Next Page
Loading...
