Device installation
Selection of the Detector Location
The controlled area and the efficiency of the security system depends on
the location of the detector.
Location of Motion Protect depends on the remoteness from the hub and
presence of any obstacles between the devices hindering the radio signal
transmission: walls, inserted floors, large-size objects located within the
room.
Check the signal level at the installation location
If the signal level is at one bar, we cannot guarantee stable operation of the
security system. Take all possible measures to improve the quality of the
signal! As a minimum, move the device – even 20 cm shift can significantly
improve the quality of reception.
If after moving the device still has a low or unstable signal strength, use
the ReX Radio signal range extender.
The direction of the detector lens should be perpendicular to the probable way of
intrusion into the room
To Next Page
Loading...
