14
Then move the coil away from the target perpendicular to the primary direction (A) scanning (e.g.
forward) along this line. This retraction of the coil in this direction must pass through the original
coordinate. Re-enable the static mode. Scan the object along the line as accurately as possible
keeping a minimum distance between the ground and the sensor. The recorded coordinate of the
maximum frequency tones sound on line B, will determine the exact location of the object. To return
to the dynamic mode press the OK button again
MODE “TURBO”
In the "Turbo" mode the search coil operates at the forced excitation current. This mode allows you
to increase the sensitivity of the device and to improve the immunity of the device from external
electromagnetic interference.
Attention! The “Turbo” mode greatly increases current consumption and as such battery operating
time is greatly reduced!
Switch to TURBO and back by using the - / TURBO button while in search mode. It is necessary to
ensure that the settings ST/RT sensitivity and volume on the display screen are not displayed.
To Next Page
Loading...
