EasyManua.ls Logo

AKA T72 - Getting Started; Power Supply

AKA T72
29 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
Control modes:
• Dynamic programmable;
• Static with adjustable threshold.
Power Supply: - 6 batteries (type AA (LR6));
Continuous operation time: - 16-18 hours in normal mode, 6-7 hours in Turbo mode
(Rechargeable batteries 2500 mAh) - up to 40 hours in economy mode
Overall dimensions, mm:
• Telescopic rod - 1200 (Max.);
• Electronic unit - 120х70х115;
• Search coils - Ø 260 mm, Ø 380 mm, 150x260 mm, 240x320 mm
Weight of the device: - 1300 g (without battery)
The device allows the ability to work in water depths of up to 15 meters, without submerging the
control box.
GETTING STARTED
Assemble the metal detector. To do this: install the appliance in a metal bar; tighten the Collet
Chuck; install the inner (plastic rod) sensor; install the rod with the sensor in a metal bar to desired
length, using the tabs and holes in the rod tightly and evenly wrap the sensor cable around the rod.
Freely hanging cables can Cause falsing; connect the sensor connector to the electronic unit.
WARNING! Do not over tighten the attachments and fittings for the telescopic shaft. This applies in
particular to the plastic bolt for the search coil and shaft collets. Thanks to a specially designed three-
knee construction shafts do not need to be disassembled for transportation, simply push the knee
shafts into each other all the way and the device is ready to be carried compactly (fig. 1)
POWER SUPPLY
The device is powered using 6 AA batteries or 6 rechargeable NIMH. Rechargeable batteries and
charger are not included and must be purchased separately. We recommend that you use NiMH
batteries from SANYO, ANSMANN 2500 capacity-VARTA or 2850 Ma/h. The use of standard alkaline
batteries is possible but not cost effective as the rechargeable batteries pay off after 4-5 recharges.
When using batteries, with a capacity of 2500 Ma/h, continuous operation is approximately 16 hours
in the main mode and 6-7 hours in Turbo mode. Several recommendations on the use of nickel-metal
hydride batteries:
-Avoid fully discharging the batteries with each cycle use as this shortens their lifespan. Slight
"memory effect" is eliminated by one complete discharge approximately once a month.

Related product manuals