Akai 1730-SS User Manual

3-VOLTAGE AND CYCLE CON-
VERSION
@ VOLTAGE
Model 1730-SS is operable anywhere in the
world, With the built-in step-down power trans-
former, the operator can easily readjust the
recorder
to
any
one
of
the
six
stages
of
power
voltage from 100 to 240 volts A.C, The operator
is requested to check the previously set voltage
before operation. If another voltage ts required,
readjustment can be made as follows:
il) Remove the FUSE POST as shown in
Fig, A. Remove VOLTAGE SELECTOR
PLUG
and
reinsert
to
standard
area
voltage.
2;
The
VOLTAGE
SELECTOR
as
shown
in
Figs.
B,C.
and
Dis
a
rotable
plug-in
type
offering
6
selections
/100/110/120/200/220/
240),
3,
Change
the
fuse
according
to
voltage,
7 =e
Velie TOOW te 120 200V ww OV |
| Le aaa |
CAUTION:
Disconnect
power
plug
from
AC
outlet
before
readjusting
voltage,
To
maintain
optimum
performance
and
prolong
the
life
of
your
machine,
it
is
important
that
the
line
voltage
be
held
within
10 percent
deviation
of
standard
voltage,
@ CYCLES
Correct tape speed cannot be obtained if the
‘
CYCLE
CONVERSION
SWITCHES
are
not
OWT 50Hz OUT SOHz properly positioned. CYCLE CONVERSION
~~ SWITCH (A) is located on the upper center
of the face panel and (B) ts located at the rear
of the recorder. Using a screw driver, rotate
CYCI.E CONVERSION SWITCH (A) coun-
ter-clockwise approximately one-cighth — of
IN
6OHz
:
;
IN
6OHz
aturn.
The
switch
can
then
be
moved
cither
OUT or IN. 50 cycle operation is obtained by
moving the switch OUT (Fig. A-1) and 60 cycle
operation, by moving the switch IN (Fig. A-2).
The switch should be rotated back to its original
position after it has been moved co either IN or
OUT | position. CYCLE CONVERSION
SWITCH (B) must also be reset accordingly,
CAUTION: Do not attempt to rotate the
CYCLE CONVERSION SWITCHES when
the motor is not running.

Akai 1730-SS Specifications

General

Brand	Akai
Model	1730-SS
Category	Tape Deck
Language	English