Akai AP-005

V. CYCLE CHANGE (MOTOR PULLEY REPLACEMENT)
MOTOR PULLEY BELT GUIDE
ALIGN
SET SPEED SELECTOR
i
©
33
RPM
POSITION
GROOVE
Fig. 3
50 Hz and 60 Hz cycle change is effected by changing
the motor pulley.
50 Hz and 60 Hz differentiation can be determined by
the groove on the 60 Hz pulley.
While viewing horizontally as shown in Fig. 3, install so
that the lower part of the motor pulley brim and the
lower part of the belt guide are lined up.
Set speed selector to 33 rpm position, install the belt
and switch on power. If a rumbling noise from the belt
can be heard and speed changing is not smooth, adjust
installation position of motor pulley.