Akai AP-Q55

AP-D33/C
V. VOLTAGE AND CYCLE CONVERSION AP-Q55/C
FUSE PCB APD-3052
MFR JAPAN SERVO
MADE IN JARAT 4 :
BLede’
F {
&
Fig. 5 Voltage Conversion (U/T Model only
—_
. VOLTAGE CONVERSION
Models for JPN, Canada, USA, Australia and Europe
are not equipped with this facility. This machine can
be set to 110—120V/220—240V as required.
Each machine is preset at the factory according to
destination but if voltage change is necessary it can be
accomplished as follows only by qualified personnel.
1) Disconnect power supply cord.
2) Remove the bottom cover.
3) Remove existing Line Voltage Fuse and insert
required Line Voltage Fuse in the proper fuse
holder according to the printed instructions.
2. CYCLE CONVERSION
With DC servo motor, cycle conversion is not neces-
sary.