Akai AP-Q55

5. RETURN PLUNGER INSTALLATION POSITION ADJUSTMENT
22
SPINDLE GEAR
GAP A
PLUNGER
SL90I
ADJUST MENT.
SCREW
Press the Reject Lever with your finger until the
Reject Plate touches the Spindle Gear when the
motor is attached as shown in the illustration, At this
time, adjust the position of the Plunger so that the
Gap A between the Reject Lever and Plunger dis-
appears.
After adjustment, confirm that the Auto Return
operates.
REJECT LEVER
REJECT
PLATE
Fig. 13