2. You will see the corresponding button on screen change from red to green if
the button has been verified to be working properly.
3. You will also see the LED under the button light. In the case of Play, Record
and Session, the LED is above the knob. Shift, Bank Select arrows, Tap Tempo
Nudge – and Nudge + have no LEDs. Verify LED lights.
4. Once all buttons have passed, the section on screen that surrounds the
buttons will turn from red to green
Pad / Soft button Test
There are several separate plastic button sections. The testing for both sections is
the same.
1. Press each button and release
2. You will see the corresponding button on screen change from red to green if
the button has been verified to be working properly.
3. You will also see the LED under the button light. Button/Pads that have RGB
LEDs will cycle colors. Bi color LEDs will also cycle colors. It will not cycle off,
therefore If you notice there is no LED under a particular button being lit, you
can conclude there is an issue with this LED.
4. Once all buttons have passed, the section on screen that surrounds the
pads/soft buttons will turn from red to green
Encoder Test
.
1. Move the two encoders(Tempo and Cue Level) to the left and to the right.
2. You will see the corresponding button on screen change from red to green if
the button has been verified to be working properly.
Slider Test
.
1. Move the 9 sliders from minimum to maximum position.
2. You will see the corresponding slider on screen change from red to green if
the button has been verified to be working properly.
3. Once all buttons have passed, the section on screen that surrounds the
pads/soft buttons will turn from red to green
Footswitch Test
.
4. Press the footswitch and release the footswitch
5. You will see the corresponding button on screen change from red to green if
the button has been verified to be working properly.
To Next Page
Loading...
Need help?
General
