RECORDING FROM AN EXTERNAL
AMPLIFIER
If an external amplifier or tuner amplifier is used, connect
the tape outputs of the external amplifier to the Line
Inputs in step E of stereo recording procedure.
RECORDING FROM A TURNTABLE
To record from a stereo or monaural disc, a crystal pick-up
can be connected directly to the Line Inputs in step E of
stereo recording procedure. If a magnetic or similar
cartridge is used, it must be connected to the Line Inputs
through an external amplifier.
TAPE DUBBING
When dubbing tape from another recorder, connect the line
outputs of playback machine to the line inputs of the
recording machine in step E of stereo recording procedure.
SOUND-ON-SOUND RECORDING
For transfer of previously recorded material from one track
to another accumulating as many individual recordings on a
single track as is desired. Use for language training or
various interesting musical compilations.
First Recording
A. Turn on Power Switch. The Power Indicator Lamp will
light.
B. Confirm that there are no connections to the Line
Input Jacks.
C. With the Reset Button set the Index Counter to
"0000".
D. Depress LEFT Track Selector Switch.
E. Insert microphone into left Microphone Jack.
F. Depress SOURCE Monitor Switch.
G. Adjust left Microphone Recording Level Control while
observing left VU Meter.
H. While holding Recording Safety Button at depressed
position, depress FWD Key. to begin first recording;
i.e., DO-RE-MI.
I. When the first recording is complete, rewind tape to
starting point.
the Din connector to the Din Jack and the black cord
Pin Plug to the left Line Input Jack.
Second Recording
J. Depress both Monitor Switches.
K. Depress RIGHT Track Selector Switch.
L. Increase Line Recording Level Control.
M. Connect stereo headphones to monitor first recording
on track 1.
N. While holding Recording Safety Button at depressed
position, depress FWD Key to begin second recording;
i.e., MI-FA-SOL.
O. Reset left Line Recording Level Control (decrease little
by little) until proper level is obtained.
The second recording is made. on track j as the rust
recording is monitored through headphones. The two
recordings. will be completely merged on track 3 ; i.e.,
DO-MI-RE-FA-MI-SOL.
Third and subsequent recordings are made in the same way
by switching LEFT and RIGHT Track Selector Switches.
For playback, set Track Selector Switch to track on which
last recording was made and depress the TAPE Monitor
Switch.
With the standard accessory l:onnection l:ord connect
I!1J
To Next Page
Loading...
Need help?
General
