Akai GXC-750D

VI. MECHANISM ADJUSTMENTS
CAPSTAN
CAPSTAN MOTOR
FLYWHEEL 8
(RIGHT)
MOTOR PULLEY
FIXATION NUT
Fig.
REEL MOTOR
. FLYWHEEL THRUST LOOSE PLAY
ADJUSTMENT (Refer to Fig. 4)
Adjust by turning flywheel thrust loose play adjust-
ment screws to obtain a 0.05 to 0.15 mm of loose
play when the flywheel is moved as indicated by the
arrow mark.
Tighten fixation nuts to maintain optimum adjusted
condition. Paint lock the adjustment screws.
MES
mw;
|
En
Жср
=
^
ғ
БЕЗ”
С,
EN = 222 25
FLYWHEEL А
(LEFT)
Ж 0.05 to 0.15 mm
ADJUSTMENT SCREWS
4 Flywheel Thrust Loose Play Adjustment
MECHA FRAME
FIXATION SCREW
REEL TABLE
Fig. 5
2. REEL TABLE INSTALLATION POSITION
ADJUSTMENT (Refer to Fig. 5)
Adjust until a clearance of approximately 3.2 mm is
obtained between the mecha frame and the lower side
of the reel table's pulley as shown in Fig. 5. Then,
tighten the fixation screw firmly.