05. Set the 'level' field to an appropriate level
If you select ANALOG in the 'Source' field, adjust the [REC GAIN] volume with using the level meter in the RECORD mode in advance. If you
select DIGITAL in the 'Source' field, the [REC GAIN] volume is not used.
06. Set 'Pan' as desired.
07. Set the 'FX' field to one of the four Effects Busses.
Be sure to select an Effects Buss which has effects assigned.
08. Set the 'Send Amt' field to the desired level.
This controls how much signal from the Input Thru source is sent to the Effects Buss. For a wetter effects signal, turn this parameter up.
Note: if the selected Effects Buss has its 'Direct Out' set to off, this parameter is hidden.
09. Set the 'Out' field to 'L/R'
You can also route the Input Thru source to one of the 8 individual outputs, in stereo pairs, or mono. Set this to OFF if you want to apply the
selected effect as an Insert type effect.
To Next Page
Loading...
