LEVEL: 0 – 100
This controls the sample volume level.
CUTOFF: -100 - +100
This offsets the cut off frequency of the filter. The value set in the PROGRAM mode is used as 0.
RESO: -100 - +100
This offsets the resonance of the filter. The value set in the PROGRAM mode is used as 0.
LAYER: 0 - 127
This value switches layers instead of Velocity.
ATTACK: 0 – 100
The attack time of the envelope will be replaced with this value.
DECAY: 0 – 100
The decay time of the envelope will be replaced with this value.
FX SEND: 0-100
This controls the FX Send level for the selected pad.
08. Press [F4] (CLOSE) to return to the Q-LINK page.
Resetting the Q-LINK slider / knob value
You can reset (back to the original value) the altered value of Q-LINK
slider/knob.
Example: When you control the Tune of the Pad Event with REAL TIME,
the Tune will keep the changed value after you change the Q-LINK slider.
If you press the [F5] (ALL R) button or the [F6] (RESET) button, the
changed value resets to its original value.
[F5] (ALL R):
All parameters changed with REAL TIME reset to the original value.
[F6] (RESET):
Only the parameter being displayed in Slider page resets to the original value.
Recording the slider/knob value in a sequence
When you use the Q-LINK slider/knob while recording a sequence, the Note Variation data will be recorded into the
track of the sequence.
When the NOTE ON is selected in the 'Change' field, the value of the Q-LINK slider/knob will be recorded as Note
Variation information with the Pad Event. When the REAL TIME is selected in the 'Change' field, the value of the Q-LINK
slider/knob will be recorded as Q-LINK event, independent of the Pad Event.
[AFTER] Button
This button sets the operation of the Q-LINK slider/knob. When a sequence is recorded, the Note Variation data is
played back. The operation of the [AFTER] button is different with 'NOTE ON' or 'REAL TIME'.
When 'NOTE ON' is selected, if the [AFTER] button is OFF (the LED is off), and you move the Q-LINK slider or knob
while playing back a sequence with Note Variation, the Pad’s Note Variation is played as recorded. If you hit a Pad
during playback, the Pad that you hit will have the effect of Q-LINK slider or knob.
If the [AFTER] button is ON (the LED is lit), and you move the Q-LINK slider or knob while playing back a sequence with
Note Variation, the Note Variation value will be replaced with the current position of the Q-LINK slider or knob.
When 'REAL TIME' is selected, if the [AFTER] button is OFF (the LED is off), and you move the Q-LINK slider or knob
while playing back a sequence with Note Variation, the recorded Pad’s sound will be changed.
If the [AFTER] button is ON (the LED is lit), the recorded Q-LINK Event
will be ignored and the current Q-LINK slider/knob position will be used
while playing back a sequence with Note Variation.
While recording a sequence,
If the [AFTER] button is OFF, when you move the Q-LINK slider/knob,
the new Q-LINK Event will be recorded and added to the existing Q-LINK
Events.
To Next Page
Loading...
