18
Editing Knobs and Sliders
The knobs and sliders on the MPD24 are controllers which can be set to transmit Control
Change or Aftertouch information. The default operation of knobs and sliders is to transmit
Control Change information when used.
What is Control Change?
Control Change refers to the use of MIDI Continuous Controller
data. Continuous Controller (CC) data are MIDI messages capable
of transmitting a range of values, usually 0-127. CC's are commonly
used for controlling volume, pan, mod wheel (#1) and other variable
parameters on your DAW or sound module.
What is Aftertouch?
Aftertouch refers to MIDI data sent when pressure is applied to a
pad after it has been struck, and while it is being held down or
sustained. Aftertouch is often routed to control vibrato, volume, and
other parameters. On the MPD24, the knobs and sliders can also be
assigned to transmit Aftertouch information.
SELECTING KNOB OR SLIDER EVENT TYPE:
1. Press [EDIT] button to enter EDIT MODE.
2. Move the slider or turn the knob that you would like to edit.
3. On Page 1, turn the [VALUE] dial to select ‘CTRL CHANGE’ (Control Change) or
‘AFTERTOUCH’ as the event type.
4. Press [ENTER] to view Page 2.
Depending on which event type you select on Page 1, parameter options on Page 2 will be changed.
5. Use [ < ] and [ > ] buttons to move through field on the second page.
The parameter fields available for each event type are outlined in following pages of this manual.
To Next Page
Loading...
Need help?
General
