18
After Sales Support 1300 886 649
5.4.2 Installation of the unit into the housing
• Slide the unit into the housing until it is rmly against the rear of the housing.
Care is required to ensure the foam sealing strips on the housing remain
in position.
• Connect the air conditioner to the power and position excess cord length
beneath the air conditioner base.
• Engage the chassis xing brackets into the bottom housing rail and secure to
the base with the screw provided.
• Remove the front panel from it's carton and plastic bag and t as per the
installation instruction.
• Switch unit on. Check for operation of the unit and check for vibration in
the installation.
• Fit the drain pan to the housing and run a drain line to a suitable location
if required.
5.4.3 Installation of the unit into the wall
To Next Page
Loading...
