Sampler functions
The other option,
P+S , allows you to load a program and all associated samples (free
memory permitting). To do this, highlight a program using the CURSOR knob, and press
P+S . The program, and its associated samples, will be loaded into memory. If the samples
required by this program already exist in memory, they will be loaded anyway, but they
will overwrite the memory samples. If there is not enough memory to load a program
and its samples, the message
"! ! insufficient waveform memory!!"will
be displayed. In this case, you will have to delete some existing programs and/or samples
to free up some memory space.
Other disk operations, like saving and formatting disks, are performed in the DISK
mode, not from this page.
Conclusion
So far, you have been using the S1000 as a preset synthesizer, loading and playing
programs from disk. However, part of the joy of using a sampler is in creating and
editing your own sounds, and the next section covers this.
a
e 31
Version 2.0 89/11
To Next Page
Loading...
Need help?
General
