Sampler functions
The next setting, NO LOOPING, does what its name suggests - it plays the sample through
without loops for as long as the key is held down. As soon as the key is released, the sound
will start to decay.
PLAY TO SAMPLE END is useful for drum trigger units such as the ME-35T and the like.
Like the previous setting, no loops are played, but an instantaneous trigger signal or key press
will play the whole of the sample (the key does not have to be pressed for the whole length of
the sample).
The last parameter, "
loop tune offset" allows you set a pitch shift for a HOLD loop by
+
50 cents (one semitone). This shift will only occur once on the first occurrence of the loop.
Subsequent loops will be replayed at the shifted pitch of the first loop, ie this tuning offset is
not an incremental process.
LIST
The LIST page does what its name implies - it provides a list of all samples in memory. In
addition to the names of the samples, it also gives the size of each sample (in 16-bit words),
the percentage of available memory currently used by the sample, and the sampling frequency
at which the sample was recorded. Use the CURSOR buttons to scroll through the list. No
data can be changed on this page.
Version 2.0 89/11
a
e 50
To Next Page
Loading...
Need help?
General
