Sam
ler functions
The next parameter allows you to set the overall volume of the program (00 to 99)
relative to any other programs being played.
The three parameters following affect the volume of the sound as controlled by three
keyboard parameters: velocity, key position, and aftertouch (pressure).
The first,
"vel>loud", can take values from +50 to -50. If this value is positive, the
higher the velocity, the louder the sound produced, and a negative value will produce a
quieter sound with a high key velocity. Setting two programs in the same keyrange, one
with this value set positive, and one with it set negative, can prcduce a velocity
cross-fading effect.
The next parameter, “key> loud", determines the volume of the sound depending on
the key being played. When this parameter is positive, the higher the key, the louder the
sound, and when negative, the higher the key, the quieter the sound (like most acoustic
instruments).
Finally, in this column,
"prs>loud" allows you to specify the effect of aftertouch on
program volume. Positive values will increase the volume as aftertouch is applied, and
negative numbers will reduce the volume when aftertouch is applied.
"mono out" specifies the output channel (OFF or 1 to 8) from which the program is
played. Note that this setting interacts with the "out" parameter in the SMP2 page of the
keygroup setting, and is used as the "base" number to which offsets set up in the SMP2
page are added. If this value is set to OFF, then the program will only be output from the
stereo connectors.
As mentioned in the guide to the rear panel, programs can be sent through the S1000's
own effects loop prior to output. The
"efct out." parameter can be set ON or OFF
individually for each program. If you are playing a large number of programs
simultaneously, then you might consider using the EFFECT OUT as an extra individual
output channel.
The "ster. 1ev" parameter allows you to set the level of the program from the stereo
outputs. It has no effect on the level from individual outputs. This parameter interacts
with all other volume settings you have made for this program, notably the
"loudness"
parameter. If the loudness parameter is set to 00, no sound will be produced from the
stereo outputs, even if the
"ster .1ev" parameter is set to 99.
a
e 61
Version 2.0 89/11
To Next Page
Loading...
Need help?
General
