AKCP SPX+ - Network Ports Used by SP+ Units

SPX+ Introduction Manual - updated until firmware 4997
- 97 -
Network ports used by SP+ units
Below we list the ports used by our SP+ units. Most of them are needed for external communications
with APS, and to use network features.
Most ports are user configurable, these are the default ports.
Main ports:
 5000 TCP for RPC with APS - note: not fully user configurable
 161 TCP/UDP for SNMP
 80 TCP for HTTP of Web UI
Other ports:
 123 TCP for NTP (Network Time Protocol) - note: port is not user configurable
 162 TCP/UDP for SNMP Trap
 25 TCP for Email SMTP (if used)
 1194 TCP/UDP for VPN (if used)
 443 TCP for HTTPS of Web UI
 502 TCP for Modbus TCP (if used)