Akeeyo AKY-710S - Video Function

Video function
Loop Video
Press the power button for 3s to turn on and enter the loop recording mode after 3
vibrations. When the capacity of Memory card reaches the limit, the system will automatically
overwrite the old files and continue recording.
Emergency Video
To use the emergency video function, you need to adjust the impact sensitivity to
high/medium/low in the APP.
Notes:
When G-sensor sensitivity is set to "High", even minor impacts trigger emergency recording.
When G-sensor sensitivity is set to "Low", only strong impacts trigger emergency recording.
Emergency recording files are locked and won't be overwritten. Backup and delete them
regularly as needed. (You can delete them via the mobile app, a card reader connected
to a computer, or by connecting the included charging cable to a computer.)
Emergency recording files are stored in the Event folder on the Memory card.
Parking Monitoring Recording:
Activate parking monitoring in the app.
When the device detects an impact while off, it flashes a red light after vibrating three
times, records for 30 seconds, then powers off after vibrating three times again.
Recorded files are locked and won't be overwritten. If too many files are locked, regularly
back them up and delete as needed. (You can delete them via the app, a card reader
connected toa computer, or by connecting the included charging cable to a computer.)
Parking monitoring records are stored in the "parking_monitoring" folder on the Memory card.
Note:
Ensure G-sensor sensitivity is set to high/medium/low in the app.
Take a picture =.
Note: The photo function can only be
operated through the mobile phone APP. eT