AKG WMS 400 User Manual (English)

Other manuals for AKG WMS 400

Quick Guide5 pages

Service Manual19 pages

Short Form Service Manual14 pages

Questions and Answers:

A
Alexander PowellAug 20, 2025
Why does my AKG Microphone system have noise and crackling?
- M
  matthew98Aug 21, 2025
  If you experience noise, crackling, or unwanted signals with your AKG Microphone system, try the following: * Relocate the receiver or antennas to a different position. * Identify and switch off any interfering sources such as other wireless systems, TV, radio, CB radios, or defective electrical appliances. Alternatively, tune the transmitter and receiver to a different frequency. Have your electrical installation checked for defects.
B
Brian GomezAug 23, 2025
What to do if my AKG Microphone system has distortion?
- A
  Andre MartinezAug 23, 2025
  If your AKG Microphone system is experiencing distortion, it could be due to a couple of reasons: 1. The GAIN control on the transmitter might be set too high or too low. Adjust the GAIN setting until the distortion stops. 2. There might be interference from other wireless systems, TV, radio, CB radios, or defective electrical appliances or installations. Try switching off these interference sources or defective appliances. You can also tune the transmitter and receiver to a different frequency or have your electrical installation checked.
M
marcbyrdAug 26, 2025
How to prevent dropouts in AKG WMS 400?
- S
  susanthompsonAug 26, 2025
  If you are experiencing momentary loss of sound ("dropouts") at some points within the performance area using your AKG Microphone system, relocate the receiver or antennas. If dead spots persist, mark and avoid them.
A
annehoffmanAug 28, 2025
What does ERR.>SYS< mean on AKG Microphone system?
- J
  Jamie WagnerAug 28, 2025
  When your AKG Microphone system displays 'ERR.>SYS
S
Steve CrawfordAug 31, 2025
What does ERR.>PRE< mean on AKG WMS 400?
- C
  Carrie MckinneyAug 31, 2025
  When your AKG Microphone system displays 'ERR.>PRE
D
deleonchristopherSep 2, 2025
What does ERR.>TXBand mean on AKG WMS 400?
- N
  Nicholas BensonSep 2, 2025
  If your AKG Microphone system displays 'ERR.>TXBand', it means that the transmitter frequency band is not identical with the receiver frequency band or the RF output is too high/low. Use a transmitter with the same frequency band as the receiver or use a transmitter with lower/higher RF output.
J
Jesus LucasSep 4, 2025
What does ERR.>USR< mean on AKG WMS 400?
- S
  Shelley JimenezSep 4, 2025
  If your AKG Microphone system displays 'ERR.>USR
K
Kevin GarciaSep 7, 2025
What does ERR.>RF< mean on AKG WMS 400?
- M
  Michele HarrisSep 7, 2025
  If your AKG Microphone system displays 'ERR.>RF
M
markstanleySep 9, 2025
What does ERR.>IR< mean on AKG Microphone system?
- J
  jmontgomerySep 10, 2025
  If your AKG Microphone system displays 'ERR.>IR
N
Nichole BeckerSep 12, 2025
What does >-h< mean on AKG WMS 400 Microphone system?
- C
  christinapachecoSep 12, 2025
  If your AKG Microphone system displays '> -h