Akuvox E16 - Step1: Wall-Mounting Bracket Installation; Installation; 1.1 with Embedded One-Gang Junction Box (86 X86 MM or 2 X3 Inches in Size) in the Wall; 1.1.1 with 86 X86 MM Embedded Junction Box in the Wall

Installaon
1.1 With embedded one-gang juncon box (86x86 mm or 2x3 inches in size) in the wall
Mark the two positioning
holes of the wall-mounting
bracket on the wall.
Insert two plastic wall
anchors into the two
drilled holes.
Use a hand drill with 5 mm diameter
bit to make two positioning holes
with 25 mm in depth in the marked
positions.
1. Step1: Wall-mounng Bracket Installaon
2
Fix the wall-mounting bracket
with two M4x30 screws and
two ST4x20 screws.
Fix the wall-mounting bracket on
the embedded box with two
M4x30 screws.
Remove the two M4x30 screws
and take off the wall-mounting
bracket.
1.1.1 With 86x86 mm embedded junction box in the wall
1.1.2 With 2x3 inches embedded single-gang box in the Wall
Finish the bracket installation.Fix the wall-mounting bracket on the single-gang
junction box with the two M4x30 screws.
E16/A05