5
2.3 Device Installaon with Digital Wrist Temperature Detector (Oponal)
Tighten the detector on to the inner
threaded bolt with two M3x6 screw
using the Allen wrench attached in the
same way on both side.
Fix the two holes of the detector
onto the installation pins on the
wall-bracket either on the left or
right according to your
preference.
Fasten the back cover with four
Torx screws using the Torx
wrench attached.
Take out the device along with
the back cover，cable locking
plate，rubber plug，and
corresponding screws.
Hang the device on to the square hanger on the wall
mounting bracket, pull down the device to make it fall
completely on to the square hanger on the wall-mounting
bracket, then use the Torx wrench attached to tighten the
device with the Torx screws.
Installation is completed.
Lead the wires from the wall-mount bracket and the detector
through the square hole on the back cover, connecting them
to the corresponding interface of the main board. And then
select a suitable size rubber plug to push all the cables into
the back cover. Fix cable locking plate to the back cover with
two M2.5x6 screws.
OR
Wire of detector
E16/A05
To Next Page
Loading...
