Akuvox E16 - 2.2 Device Installation with Digital Forehead Temperature Detector (Optional)

4
Installation is completed.
Hang the device on to the square hanger on the wall mounting bracket,
pull down the device to make it fall completely on to the square hanger
on the wall-mounting bracket, then use the Torx Wrench attached to
tighten the device with the Torx screw.
2.2 Device Installaon with Digital Forehead Temperature Detector (Oponal)
Fasten the detector on to the nuts on the device’s rear cover with two M3X10.5
screws using the Allen wrench attached, and lead the wires from the wall-mount
bracket and the detector through the square hole on the back cover, connecting them
to the corresponding interface of the main board. And then select a suitable size
rubber plug to push all the cables into the back cover. Fix the cable locking plate to
the back cover with two M2.5x6 screws.
Hang the device on to the square hanger on the wall mounting
bracket, pull down the device to make it fall completely on to
the square hanger on the wall-mounting bracket, then use the
Torx Wrench attached with to tighten the device with the Torx
screw.
Installation is completed.
Take out the door phone and the
digital forehead temperature
detector and then take out back
cover,cable locking plate,and
rubber plug.
Fasten the back cover with
four Torx screws using the
Torx wrench attached.
E16/A05