Akuvox R20A Quick Guide

R20A
Wall-mounng Installaon
Warranty
1. Akuvox warranty does not cover intentional mechanical damage or destruction caused by improper installation.
2. Do not attempt to modify, alternate, maintain, or repair device by yourself. Akuvox warranty does not apply to damages
caused by anyone who is not representative of Akuvox or an Akuvox authorized service provider. Please contact Akuvox
Technical Team if the device need to be repaired.
Device Test
Please verify the device status after installation:
1.Network: Press and hold Call button to obtain IP address, network is working properly if the device announce IP
address. If no IP address is obtained, E12X will announce “IP 0.0.0.0”.
2.Intercom: Press Call button to make a call. The call configuration is correct if the call is successful.
3.Access Control：Use pre-configured RF card to unlock door.
Information contained in this document is believed to be accurate and reliable at the time of printing. This
document is subject to change without notice, any update to this document can be viewed on Akuvox’ s website:
http://www.akuvox.com © Copyright 2023 Akuvox Ltd. All rights reserved.
Notice Information
Get Help
For help or more assistance, contact us at:
https://ticket.akuvox.com/
support@akuvox.com
Scan the QR code to get more videos, guides, and additional product information.
10

Akuvox R20A Specifications

General

Audio	Built-in Microphone and Speaker
Installation	Wall-mounted
Ingress Protection	IP65
Card Reader	13.56MHz, Mifare
RS485	Yes
Camera	2MP
Network	10/100Mbps Ethernet
Protocols	SIP
Power	PoE or 12V DC
PoE	IEEE 802.3af
Relays	1
Input	2