4
1.Place the device into the wall-mounting box/
flush-mounting bracket until the edges of which
align to the wall. Then pull the device downward
and ensure the groove of it hooks to the lock
catches of the back box.
2.Use the Allen wrench to tighten the device with
two
M3x6 screws.
Wall Mounting
Flush Mounting
Use four M3x5 screws to fix
the back cover.
Make cables go through the back cover, connecting
to the corresponding interfaces of the main board.
Choose a suitable size rubber plug to compress
cables, then fasten the locking cable plate with two
ST1.7x4 screws.
For convenient wiring, hang
R27X on the wall-mounting
box/flush-mounting bracket
with rope. Then insert the
silicon rubber sealing ring
into the groove.
To Next Page
Loading...
