4.
Installation
1. Connect Ethernet to the available ports.
2. Connect the panel’s relays to the building’s door strike.
3. Connect Panel to PoE OR> Power Supply > UPS > Wall Outlet.
The Panel will start up like a computer. After loading, you should see the
Akuvox software.
5.
Test Relays
1. In the Dial interface, press "9999"->"Dial key"->"3888"->"OK" to enter the
system setting.
2. Press "RFCard"->"Add Card" to add RF Card by putting the which near the
RF card reader.
3. Back to home page to place the predefined users card in RF card reader to
unlock.
If successful, you will hear a chime "Welcome, please coming" from the panel
and see a message "Opening door succeeded" on the panel. The door strike
(or other connected system) should respond
Tip: For more installation details, please refer to the Quick Guide.
To Previous Page
Loading...
Need help?
General
