10 11
Connect to the system
❶ Put the thermostat in OFF mode
(no mode icons are lit).
❷ Put the Z-wave controller in inclusion mode.
Refer to the controller documentation
for more information.
❸ Press and hold the DOWN button
on the thermostat to begin inclusion mode.
Release the button when the RADIO
icon lights up.
❹ When the RADIO icon becomes solid,
the thermostat has been included.
❺ Log in to your online customer account
to sync the thermostat with the system
or contact your service provider for
professional installation setup.
NOTE: Write your login information below
once you have chosen a personal password.
User ID
Password
Attach the body and back plate
Verify that any excess wire is tucked back into
the wall to allow room for the thermostat to sit
flush against the back plate.
Return the thermostat to the wall plate by
pressing the thermostat body firmly into the
back plate mounted to the wall. Ensure that
the pins on the body are correctly aligned with
the back plate. Failure to do so could cause
damage to the thermostat.
Turn the power on
Restore power to all the heating and
cooling systems. This can be done at the
circuit breaker.
To Next Page
Loading...
Need help?
General
