Alba 411013 - Telescopic Aerial Usage; Powering On and Standby; Mode Selection

Using your Mono DAB/FM Radio
Let’s get started
Using your Mono DAB/FM Radio
18
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
Telescopic aerial
Please make sure that the aerial is fully extended before you switch on your radio and
attempt to tune to a DAB station (a vertical position is recommended). This will ensure that
the maximum signal strength is available when the radio begins to scan. Extending the
aerial also ensures the best possible sound quality.
Switch on
1. Press and release the Power button on the top of your radio. Your radio will switch on
and begin an automatic scan for DAB stations. A progress bar will show the progress
of the scan and the number of stations found during the scan will also be displayed.
Note: When using battery power, your radio will scan for DAB stations after you slide
the On/Off power switch on the back of the radio to On. There is no Standby mode
when you are using battery power.
2. When the scan is complete your radio will select the first available station and begin to
play. Stations are listed in numerical and then alphabetical order by default.
Note: The DAB radio station list is stored in the memory and so the next time you
switch your radio on, the station search does not take place. It is possible to scan
manually for stations by pressing and releasing the Scan button.
Adjusting the volume
• Turn clockwise to increase the volume.
• Turn anti-clockwise to decrease the volume.
• Check the display, which will confirm the volume setting.
Change the mode
Press and release the Mode button to change between DAB and FM modes. Please check
the display, which will confirm the mode.