FM Radio mode
If you are not already in FM mode, press and release the Mode button to go to FM mode
(check the display).
If you were listening to an FM station when you switched the Radio off then this station
will be automatically selected when you switch the Radio back on.
Tuning to an FM station
• Press and hold the Next button to scan up the frequency band.
• Press and hold the Prev button to scan down the frequency band.
• Press and release the Next or Prev button to fine tune each frequency in 0.05MHz
steps.
Note: If reception is still poor try moving the radio to another location.
Changing the Scan setting
In FM mode:
1. Press and hold the Menu/Info button to enter the menu options.
2. Press and release the Next button until FM <Scan setting> is displayed. Press and
release the Select button. The current Scan setting will have an ‘*’ in the display.
There are two different options to choose from:
• Strong stations - The scan will only stop when a strong signal strength is received
which should also result in a better audio quality. It is possible that the station you
are scanning for may be missed using this option.
• All stations - The scan will stop for every station it receives, even if the signal
strength is poor.
3. Press and release the Next button to choose from the two options available and press
and release the Select button to confirm.
To Next Page
Loading...
