Alba 411013 - Cancel the Sleep Timer; Display Backlight Timeout

Using your Mono DAB/FM Radio
Let’s get started
Using your Mono DAB/FM Radio
30
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
Cancel the Sleep timer
With your radio switched on (not in Standby mode):
1. Press and hold the Menu/Info button to enter the menu options.
2. Press and release the Prev or Next buttons to scroll to <System>. Press and release the
Select button.
3. Press and release the Prev or Next buttons to scroll to <Sleep>. Press and release the
Select button.
4. Press and release the Prev or Next buttons to scroll to Sleep off. Press and release the
Select button. <Sleep> will be displayed.
Display backlight timeout
You can adjust the display backlight timeout. Options of permanently On, 10, 20, 30, 45,
60, 90, 120, and 180 seconds are available. An ‘*’ will be displayed next to the current
setting.
With your radio switched on (not in Standby mode):
1. Press and hold the Menu/Info button to enter the menu options.
2. Press and release the Prev or Next buttons to scroll to <System>. Press and release the
Select button.
3. Press and release the Prev or Next buttons to scroll to <Backlight>. Press and release
the Select button.
4. <Timeout> is displayed. Press and release the Select button. Press and release the
Prev or Next buttons to scroll through the available backlight timeout options of On,
10, 20, 30, 45, 60, 90,120 or 180 seconds. Stop when the backlight timeout you would
like is displayed and press and release the Select button. <Timeout> will be displayed.
You can now use the Prev or Next buttons to scroll and the Select button to confirm,
as you did to set the Backlight timeout, to change the settings for the backlight
brightness for the <Dim level> and <On level>. There are 3 options available, High,
Medium and Low.