Alber e-fix E36 - 3. Parameter table; System Parameters; User Mode Parameters

8
9
3. Parameter table
System
Description
Selectable parameters
Description Selectable parameters
Brake applied
• Immediately
• 30 seconds
Joystick deflection
• 100%
• 80%
• 60%
• 40%
Automatic cut-off
• 10 minutes
• 20 minutes
• 30 minutes
• 1 hour
• 2 hours
• 4 hours
• 8 hours
Joystick axle change
• Standard
• forwards/backwards
• right/left
• both axles
Menu function
• Off
• On
Set factory setting • Yes
• No
Factory pre-sets
Factory pre-sets are bold and underlined
User Mode
Description Selectable parameters Description Selectable parameters
Maximum speed forwards
• 6.0 km/h 3.73 mph **/***
• 5.0 km/h 3.11 mph *
• 4.0 km/h 2.49 mph
• 3.0 km/h 1,86 mph
• 2.5 km/h 1.55 mph
• 2.0 km/h 1.24 mph
• 1.5 km/h 0.93 mph
• 1.0 km/h 0.62 mph
Delay
• 1.5 seconds
• 2.0 seconds
• 2.5 seconds ***
• 3.0 seconds **
• 3.5 seconds
• 4.0 seconds *
• 5.0 seconds
• 6.0 seconds
Maximum speed backwards
• 70%
• 60%
• 50%
• 40%
• 30%
Turning speed
• 40%
• 35%
• 30% ***
• 25%
• 20 % */**
• 15%
• 10%
Acceleration
• 1.0 seconds
• 1.5 seconds
• 2.0 seconds ***
• 2.5 seconds **
• 3.0 seconds
• 3.5 seconds *
• 4.5 seconds
• 5.0 seconds
Turning acceleration
• 0.04 seconds ***
• 0.06 seconds
• 0.08 seconds **
• 0.10 seconds
• 0.15 seconds
• 0.20 seconds
• 0.25 seconds *
IMPORTANT
When the e-fix is initially delivered, the parameters visible in the table (bold and underlined) are predefined as the factory settings for
the drive modes ECO*, TOUR** and SPORT***. However, when the Programming-Indep.user mode menu is called up, only the factory set-
tings for TOUR drive mode are displayed on the control unit’s display screen.
If one of the parameters is changed, it affects all the drive modes - ECO, TOUR and SPORT are then no longer available for selection.
Instead, the control unit’s display screen indicates CUSTOM mode, which comprises all the selected parameters in the
Programming-Indep.user mode menu.
ECO, TOUR and SPORT can be restored to the settings specified in the table at any time using Programming-System-Set factory settings.