19
5.4 Error messages
The tables below list the errors that may occur in the e-motion wheel, together with potential measures that can be taken to resolve them.
LED display Number
of sounds
Sound interval
(seconds)
Error description Remedy
○○○○●
Steady red
light
1 1 The battery is either defective or
has a very low charge.
Charge the battery.
If the error persists, please contact your special-
ist dealer or the Alber Service Centre.
●○○○●
Steady red
light
2 2 Internal drive/battery error Avoid driving downhill with the batteries fully
charged. If necessary, switch off the e-motion
drive wheels and allow them to cool down.
If the error persists, please contact your special-
ist dealer or the Alber Service Centre.
○●●●○
Steady red
light
3 2 The push rim sensor is either
defective, or has been actuated
during the start-up process or
remote operation.
Avoid actuating the push rims during start-up.
Actuation of the push rims is not allowed when
remote operation is active, as this function can
only be used to control an unoccupied wheelchair.
If the error persists, please contact your special-
ist dealer or the Alber Service Centre.
●●●●●
Steady red
light
5 2 The drive wheel was moved
during charging, or an charging
error or defect has occurred.
Avoid moving the e-motion drive wheels during
charging.
If necessary, remove the charger from the drive
wheels and unplug the mains plug. If necessary,
repeat the charging process.
If the error persists, please contact your special-
ist dealer or the Alber Service Centre.
○○○○●
Flashing
white
4 4 WARNING! The battery has
reached critically low voltage.
Charge the battery.
●○○○●
Flashing
white
4 4 Drive/battery temperature warn-
ing
Avoid driving downhill with the batteries fully
charged. If necessary, switch off the e-motion
drive wheels and allow them to cool down.
If the error persists, please contact your special-
ist dealer or the Alber Service Centre.
●●●●●
Flashing
white
4 4 The ambient temperature during
charging is too low (< 0°C) or
too high ( > 40°C).
The charging process has been aborted. Always
charge the e-motion drive wheels at temperat-
ures between 0°C to 40°C, otherwise the batter-
ies may become damaged.
If any error messages other than those listed here appear, there is a serious system malfunction. In such cases,
the e-motion wheel cannot be used and must be sent to Alber GmbH via your specialist dealer for testing.
In the event of a problem or tyre damage, contact your specialist dealer.
To Next Page
Loading...
