20
8. Anti-tippers (optional accessories)
As your wheelchair may already be equipped with anti-tippers, Alber anti-tippers are
only offered as optional accessories. The use of original anti-tippers is subject to the
instructions and safety information that apply to their use and are provided by the
manufacturer.
When using Alber anti-tippers, two further brackets are fitted to your wheelchair in which
the anti-tippers are inserted. The following instructions and safety precautions apply.
8.1 Fitting and removing Alber anti-tippers
• Switch off the twion wheels before fitting the anti-tippers.
• Remove the quickpin [13] from the bracket mounting fork [16], by pressing on the pin
with your thumb whilst pulling it out using your index and middle finger.
• Push the clamping piece for the anti-tipper [14] into the bracket mounting fork [16].
• Lock the bracket mounting fork [16] using the quickpin [13]. To do this, press the pin
with your thumb and then push it fully into the bracket as far as it will go.
• Check the quickpin [13] holds fast in the bracket mounting fork [16]. It must not be
able to be removed without pressing the releasing device.
• Fit the second anti-tipper.
The anti-tippers are removed in the reverse sequence.
To Next Page
Loading...
