Alcatel-Lucent 1830 PSS-36 - Page 409

WEBUI Select the card, click the Reboot tab, select Warm Reboot >Submit.
...................................................................................................................................................................................................
8
Remove the pluggable module from the port on the card it is inserted in. Examine the
connector on the pluggable module and the receptacle connector on the card where the
pluggable module plugs into for any damage. If no damage is seen, reinsert the pluggable
module into its port.
...................................................................................................................................................................................................
9
Remove and replace the pluggable module with another unit of the same type, being
careful with the connected fiber jumpers. Refer to “Replacing an SFP Module” (p. 3-27).
...................................................................................................................................................................................................
10
Perform a cold reset of the card.
Note: Refer to Caution at the beginning of this procedure.
CLI config card card_type shelf slot reset cold
WEBUI Select the card, click the Reboot tab, select Cold Reboot >Submit.
...................................................................................................................................................................................................
11
Reseat the card. Refer to “Reseating a Card” (p. 3-19).
...................................................................................................................................................................................................
12
Replace the card. Refer to “Replacing System Components” (p. 3-20). Follow the return
and repair process in the Customer and Product Support guide to return the faulty card to
an authorized repair center for replacement.
Trouble-clearing procedures
LOS
LOS (Loss of signal)
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
2-159
E ND OF STEPS
...................................................................................................................................................................................................